•   Alltid produkter hemma för demo/utlåning
  •   Faktura & delbetalning
  •   Fri frakt
  •   Snabba leveranser
Brinkmann Pi Brinkmann Pi

Brinkmann Pi

19 000 kr
Finns i lager

MC-pickup från Brinkmann

The cartridge »Pi« has been developed together with our tonearms. With an ingenious mounting of the different parts, the case is highly resonance optimized and with its dynamic mass corresponds perfectly with our tonearms. Due to its neutrality it complements most other tonearms as well.  

On the »Pi« cartridge we decided to use a Micro Ridge stylus, which has the best resolution in the fi nest recorded details and which guarantees for the most reliability. Naturally sounding in the midrange with good fl exibility it gives a big room imaging in three-dimensionality on the highest level of top cartridges  

The stylus is mounted on a boron cantilever and drives a copper voice coil. Most attention was given to the rigidity of the magnetic circuit to prevent eddy currents. The MC cartridge has a similar output voltage as our EMT-ti. By this it drives preamp inputs in their best dynamic range. Due to its relatively high output voltage even on quite insensitive inputs the smallest signals will not be lost in the noise fl oor. The cartridge works perfectly on loads of 600 Ohms and matches best to our phono preamps. The cartridge has an own mass of 14 grams which leads to a high trackability with a tracking force of 1.8 to 2.0 ponds. The »Pi« will be delivered with special screws that optimize the coupling to the headshell.  

»Dynamics, fine and coarse structures, dimensionality - all that is on a very high level. So we immediately grow fond of the new cartridge. It plays very close to the top references and it‘s the recommendation for everyone who wants to listen on a very high level without spending a huge sum of money. The Pi is a strong opener and a luminating sign to the analogue passion of the Brinkmann products - not only for their own turntables.  



Type: Moving Coil 

Weight: 14 g 

Stylus: microridge, radius 3 µm 

Compliance: 15 µm/mN 

Tracking force: 1,8 g 

Vertical tracking angle: 23° 

Output voltage: 0,15 mV (velocity 1 cm/sec) 

Output impedance: 20 Ohm 

Load (recommended): 600 Ohm 

Frequency response: 0 Hz....30 kHz 

Frequency intermodulation: 0,5 % 

Crosstalk: 25 dB (1 kHz) 

Body: Three-piece resonance optimised luminum body


Drift & produktion: Wikinggruppen